Limit-dn phone-type max-lines Example: Router(config-cm-fallback)# limit-dn 7945 2 You must reboot the router to reduce the limit of Cisco IP phones after the maximum allowable number is configured. See Compatibility Information for further details. Max-ephones max-ephones Example: Router(config-cm-fallback)# max-ephones 24Ĭonfigures the maximum number of Cisco IP phones that can be supported by the router.
![magicjack router configuration magicjack router configuration](https://i2.wp.com/www.moushigo.com/wp-content/uploads/2017/07/magicjack.jpg)
You must reboot the router to reduce the limit of the directory numbers or virtual voice ports after the maximum allowable See the Configuring Call Rerouting section for more information on using the max-dn command with the alias command. Setting the alias command preference keyword allows the default preference set with the max-dn command to be overridden. The alias command also has a preference keyword that sets alias command preference values. Default is 0, which is the highest preference. Sets the global preference for creating the VoIP dial peers for all directory numbers that are associated with Allows IP phones in Cisco Unified Communications Manager fallback mode to have a virtual voice port with two See Compatibility Information for further details.ĭual-line (Optional). The maximum number is platform-dependent. Max-directory-numbers:Maximum number of directory numbers (dns) or virtual voice ports supported by the router. Sets the maximum number of directory numbers (DNs) or virtual voice ports that can be supported by the router and activates Max-dn max-directory-numbers Example: Router(config-cm-fallback)# max-dn 15 dual-line preference 1 Ip source-address ip-address Example: Router(config-cm-fallback)# ip source-addressĮnables the router to receive messages from the Cisco IP phones through the specified IP addresses and provides for strict max-dn max-directory-numbersĬall-manager-fallback Example: Router(config)# call-manager-fallbackĮnters call-manager-fallback configuration mode.To configure Cisco Unified SRST on the router to support the Cisco Unified IP Phone functions, use the following commands Manager fallback mode because phones retain the same configuration that was used with Cisco Unified Communications Manager. When the Cisco Unified SRST is enabled, Cisco Unified IP Phones do not have to be reconfigured while in Cisco Unified Communications
![magicjack router configuration magicjack router configuration](https://the-gadgeteer.com/wp-content/uploads/2011/07/MJ101-500x355.jpg)
![magicjack router configuration magicjack router configuration](http://3.bp.blogspot.com/-1ck5bCkSkhE/UPwFW3cpD5I/AAAAAAAAAWQ/HokK82dvZS0/s1600/magicjack%2Bplus.jpg)
Information About Setting Up Cisco Unified IP PhonesĬisco Unified IP Phone configuration is limited for Cisco Unified SRST because IP phones retain nearly all Cisco Unified CM
#Magicjack router configuration how to
How to Set Up Cisco IP Communicator for Cisco Unified SRST.Information About Setting Up Cisco Unified IP Phones.For a complete list of IP phones, see Compatibility Information. This chapter describes how to set up the displays and features that callers will see and use on Cisco Unified IP Phones duringĬiso Unified IP Phones discussed in this chapter are just examples. Setting Up Cisco Unified IP Phones using SCCP